Hi All - really could use the help of this community! My 6 yr. Tip: Load the nand on source to have quicker results. Should I talk to another Forum instead of this forum ?

Somewhere, or there will not be the solution to the case similar ? What should I do next ? What should I examine my motherboard ? In order to repair, I have searched team xecuters Forum, but, similar problems are not found. My xbox is broken? I destroyed my motherboard ? Then the center lights up a red LED next, no other reaction happens. Only a)HDMI cable for monitor, b)power supply, c)powerup switch are connected.Īfter power-on, immediately the center portion of the switch is lit green LED only 1-2 seconds, In order to confirm whether xbox boot up normally, I have removed all solder part, including the QSB kit. The console outputs at that time are shown in the end of this post. But JR stopped without NAND read, issuing the following message.ġ) review the solder part and partial re-soldering ( but finally failed)ģ) re-connect the USB connection of the JRP and PC,ĥ) select several menus of JR, namely such as powerup menu, To read NAND by using JR Programmer V2( Abbreviated as JRP below ),I soldered using Corona QSB Install Kit V3.Īfter soldering ( in fact this was poor soldering), anyway, I have a Corona V1 xbox360, and this is a first time RGH execution. Bad Block ID 0x39F Found 0x3FEĪlso Added some pics to show you guys it is a Opus and not trying to RGH a Xenon.So now i am on a mission to find out if its the NAND or a Dead CPU I have done many RGH's before so i don't think i killed the CPU I didn't even lift any pads. He Reballed the GPU and still had 0022 he looked all over for Traces and all looked fine, He said ' It does cycle a few times before throwing the 0022 error, which leads me to believe that it could be NAND related, or a component that failed - one that I can't locate (other than the GPU)'. I flashed it back to stock with a Bad Block tried to turn it on still RROD so i sent it off to xJonnyGunsx Some of you may know him. It just would not boot I did read the NAND and got the bad blocks as you can see down there. So i tried the RGH1 it is on dash 13604 because i saw some where that Xell should work with RROD still. So i got this console off eBay, I forgot the Error it had but i think it was 0022 or 0102.

Jr programmer v2 drivers download